San Diego Plastics
2220 McKinley Avenue
National City  CA  91950
800/925-4855   619/477-4855   FAX 619/477-4874

ACRYLIT SKYLIGHT & SIDELIGHT PANELS

Installation Instructions

[]

Installation Instructions
 

Cutting: Panels can be cut using power or hand saws. Saw blades should be fine-toothed carbide tipped or safety fabric reinforced abrasive disc. Face shields and appropriate safety equipment should be worn by all operators.
 
 
Drilling: All panels should be pre-drilled not less than 1-1/2'' from the panel end, and the holes drilled a minimum of 1/16'' larger than the fastener diameter. Panels can be drilled singly or several at a time.
 
Fasteners: When possible, fasteners should be installed at high points of the corrugation with spacings of 6'' to 8'' on center at panel ends, and 12'' to 16'' on center for intermediate purlins and siding applications.
 
Installation: UNDER NO CIRCUMSTANCES SHOULD PANELS BE ALLOWED TO SUPPORT UNDISTRIBUTED LOADS SUCH AS THE WEIGHT OF A HUMAN BODY. USE ONLY APPROVED ROOF LADDERS FOR INSTALLATION

 

2 Page Spec Sheet
 Download File

6 Page Brochure
 Download File


 
 
 
                    SEND ME MORE ACRYLIT FRP INFORMATION

Mr. Necktie
Email:*            
Name:*             
Company*:          
Address:*          
City, State, Zip:* 
Country:           
Voice Phone:*      
Fax Phone:         
     
Note:*


*Required information
  Press to send your message.

Press to clear the form and start over.

Return
To MAIN
Site
Map
Search
Me
Return To
Linecard
Sales
Terms
Contact
Me