SAN DIEGO PLASTICS - ABS PLASTIC

2220 McKinley Avenue
National City CA 91950
800/925-4855 619/477-4855 FAX 619/477-4874

ABS

Acrylonitrile Butadiene Styrene

ABS is an easily machined, tough, low cost rigid thermoplastic material with high impact strength, ideal for turning, drilling, milling, sawing, die-cutting, shearing .

Natural and Black ABS are made from FDA approved material. FDA White and custom colors quoted upon request. Flame Retardant ABS quoted upon request .

General Applications:
* Machine parts
* Prototypes
* Tote bins and trays
* Automotive parts
* Business machine housing and parts
* Aircraft interior trim
* Industrial enclosures
It has good chemical and stress cracking resistance to inorganic salt solutions, alkalis, acids, and some oils. ABS has excellent abrasion resistance; electrical properties, moisture and creep resistance .

PROPERTIES A.S.T.M Test Method ABS

Specific Gravity D792 1.02

Water Absorption Method A D570 0.3

Tensile strength at yield, 1000 psi D638 6.0

Elongation at yield, % D638 2.5

Elastic Modulus in Tension, 10~5 psi D638 4.0

Flexural Strength at yield, 1000 psi D790 12.9

Elastic modulus in flexure, 10~5 psi D790 4.4

Compressive strength at yield, 100psi D695 11.2

Elastic modulus in compression, 10~5, psi D695 2.3

Rockwell Hardness (Method A) D785 R96

Izod impact strength, ft-lb/in. notch 1/8 in. speciman D256 10.0

Deform. under load(2000 psi; 122f), % D621 0.15

Deflection temperature, F at 66 psi fiber stress D648 180

Max recommended service Temp., F intermittent use -=- 220

Max recommended service Temp., F continuous use -=- 180

Coeff. of Linear Thermal Expansion, F D696 5.7 x 10~5

Underwriters' Lab Rating (Subj. 94) -=- HB

Dielectric strength, v/mil, short time D149 357(1/8)

Dielectric constant at 60 Hertz D150 30 - 50

Dielectric constant at 1 MegaHertz D150 2.8 - 3.8

Dissipation factor, at 60 Hertz D150 .004 - .034

Dissipation factor, at 1 MegaHertz D150 .006 - .011

Volume resistivity, ohm-cm D257 10~13 - 10~16

Arc resistance (SS Electrode), sec. D495 97(1/8)

These values are representative of those obtained under standard ASTM conditions and should not be used to design parts which function under different conditions. (Somebody made me say that...)

BUY ABS ONLINE BY CLICKING ONE OF THE FOLLOWING

ABS RODS

ABS PLATE

ABS EXTRUDED SHEET

SEND ME MORE ABS INFORMATION

Email:* Name:* Company*: Address:* City, State, Zip:* Country: Voice Phone:* Fax Phone: Note:*

*Required information
Press to send your message.
Press to clear the form and start over.

Return
To MAIN

Contact
Us